How To Activate built-in hidden super Administrator Account in Windows 10-8-7 (See Its Benefits)

In Windows XP and the earlier Windows versions, there was only one Administrator account, and most single users used it as their main account. But Windows Vista and later, i.e. Windows 10 and Windows 8/7, have another built-in Administrator account, what may be referred to as a secret hidden super administrator account. It is hidden & turned off by default, and is similar to the ‘root’ account in Unix.
The use of the Administrator account is being phased out in Windows Vista, and there’s actually seldom a need to use it, instead of another administrator account. On installation of Vista, the Administrator account is disabled; but if you upgrade from Windows XP and Administrator is the only active local administrator account, then Administrator remains enabled. In this situation, it is placed in Approval Mode, for purposes of UAC. Since it is not subject to UAC prompts and runs with full administrative privileges, it’s rather risky, to run it on a regular basis. Any application could then have full control of the computer. 

So I suggest using it sparingly, only when you need to perform several administrative and don’t want to be bothered by UAC prompts. Initially, this ‘super’ Administrator account does not have a password, a serious vulnerability for a full-fledged administrator account. Best to assign a strong password to this account at the earliest opportunity.

Enable Windows Super Administrator Account

To enable, activate or turn on this Super Administrator account, type CMD in the search box. CMD will appear at the top. Right-click on it to ‘Run as administrator’.
To enable this account, type this command & hit Enter:
Net user administrator /active:yes
To disable this account, type this command & hit Enter:
Net user administrator /active:no
Activate Windows Super Administrator Account
If you decide that you need a password for the administrator’s account that you are going to activate or if you are unable to activate it with a blank password run the following commands:
Net user administrator [email protected]$$w0rd
Net user administrator activate:yes
You will get a message: The command completed successfully. (Where [email protected]$$w0rd has been taken as an example password)
Switch user and log on using this password.
Alternatively, you may also type secpol.msc in the search box and hit Enter. This will bring up the Local Security Policy.
Local Security Policy.
In the left side click on Local Policies > Security Options.  Now on the right side you will see the first entry as Accounts:Administrator Account – Disabled Right-click on it > Click Properties > Enable. Close.
And why would you want to operate this account?
  1.  You don’t want to be ‘annoyed’ by UAC.
  2. This ‘super’ administrator account has elevated privileges. This means that you can run CMD with unrestricted access to the command line.
  3. You need to carry out some serious troubleshooting.
  4. You have locked out your main account by accident, and you want a back door entry.